InstantForum.NET v4.1.4Dremel Message Boardhttp://messageboard.dremel.com/messageboard@dremel.comFri, 20 Nov 2009 21:09:46 GMT20http://messageboard.dremel.com/Topic5672-21-1.aspxChotu,</P><P>I don't see why not! I would use a straightedge to draw a line on the flat backside of the trim at whatever angle you want to cut the trim. If you have a steady hand you could follow the line freehand with your Dremel using a standard spiral cutting bit, but I would clamp a straightedge to the the trim to use as a guide fence.</P><P>I hope this helps!</P><P>Sincerely,</P><P>RonWed, 10 Jun 2009 08:42:42 GMTRon34443http://messageboard.dremel.com/Topic5672-21-1.aspxIs it possible to create a miter joint from pieces of trim, using a Dremel attachment? I need to create a small picture frame.Sun, 31 May 2009 07:13:00 GMTchotu