Dremel Message Board / New Dremel Product Discussions / Share your experience with the Stylus! / Need Advice / Latest Posts

RE: Need Advice

Barry Burns — Thu, 12 Feb 2009 17:43:40 GMT

Doug

I had the same problem with thin bits. I have been using dental bits for some very small work. The smallest collet did not tighten around the dental bit. I changed to the chuck but had the same problem. The chuck did not screw in far enough to tight around the bit. The problem as solved when I took of the collar ust behind the check. I can now tighten down the chuck as far as I want.

Barry

RE: Need Advice

Dougmo60 — Mon, 24 Dec 2007 15:00:39 GMT

I use the Dremel chuck on two of my Dremels the flex shaft is the only one I use collets.

RE: Need Advice

jet — Mon, 24 Dec 2007 13:22:40 GMT

I had the same problem, I then changed to the Demel Chuck #4486 and it worked fine with all sizes of bit shafts.:)

RE: Need Advice

Dougmo60 — Sun, 23 Dec 2007 07:32:53 GMT

One thing I forgot check to make sure you have a collet in the tool. Take the nut off and make sure the silver thing with 4 splits in the side.

RE: Need Advice

Dougmo60 — Sun, 23 Dec 2007 07:23:47 GMT

I don't know this for sure as I am not there but it sounds like your collet is bigger than your bit. Dremel makes 4 sizes of collets 1/8", 3/32", 1/16", and 1/32". I use the Dremel Chuck Model 4486, in my Dremel, works like a drill chuck. I use the collets in my flex shaft.

But you might check this and see if the collet size is to big which I'm sure it is. Not all kits come with all the collets you can purchase them at your local hardware or Wal-Mart or lots of places were they sell tools. It is Model #4485 package which comes with all 4 collets.

Need Advice

djk — Sat, 22 Dec 2007 20:42:22 GMT

I can't get the collet to close on the bit I'm trying to use. I keep tightening the collet nut but the shaft of the bit seems too small and it can be pulled out easily. Any advice?