Dremel Message Board / New Dremel Product Discussions / Share your experience with the new Stylus! / Pipe Making / Latest Posts

RE: Pipe Making

kamcclintock — Mon, 29 Jun 2009 13:18:38 GMT

Thanks for the information and a different point of view. I will try that too.

RE: Pipe Making

Dougmo60 — Mon, 29 Jun 2009 12:35:42 GMT

That sounds like a good idea. I haven't made one before seems like the stem would be the hardest part to make. I don't know what kind of bits to use but I have a wide selection so I'll work it out.

My idea is to use Walnut and a jigsaw or bandsaw to rough it out. Then use a drill with a big bit like a 1/2 inch and drill the hole in with a smaller bit for the stem. Then use a sanding band to finish the out side. Then a high speed cutter to finish the inside. Like I said this is just one idea I'm sure there are other ways to do it.

Pipe Making

kamcclintock — Mon, 29 Jun 2009 11:32:17 GMT

****o everyone,

I just bought my first Dremel and am wanting to make a tobacco pipe. I was wondering if any one has made a tobacco pipe with their Dremel. If so, what did you use to make the pipe? Any guides or advice would be great. I look forward to hearing what information you all have to share.