|
|
|
Junior Member
 
Group: Forum Members
Last Login: 2/22/2009 12:07:44 AM
Posts: 12,
Visits: 20
|
|
The doors on my pet carriers had become so rusty I am embarrassed to go to the vet's. It finally occurred to me it would be a good Dremel project. I'm using my Dremel 300 with a FlexShaft attached (the 300 is hanging from a Work Station), and a 428 carbon steel brush.
Even though I had read the directions, by the time I started the project I forgot and went a little too fast and didn't angle the brush properly (about 15 degrees). As a result, there was a lot of bristle breakage initially. Bringing the speed down to a "2" and slightly angling the brush for better contact resolved that problem.
It's working great and the doors I've completed look 100% better.
My next project will be the rusty toilet bolts. I'll use my cordless 10.8V for that one.
|
|
|
|